Shift Linkage: Service and Repair
TRANSAXLE CONTROLREMOVAL AND INSTALLATION
CAUTION: When removing and installing the transaxle control cable and shift lock cable unit, be careful not to hit the SRS-ECU.
Pre-removal And Post-installation Operation:
Removal Steps 1-7:
INSTALLATION SERVICE POINTS
>>A<< SHIFT LOCK CABLE UNIT INSTALLATION
1. Selector lever to P position.
2. Turn the ignition key to LOCK (OFF) position.
3. Install the shift lock cable unit rod to the selector lever assembly lock cam, and tighten the shift lock cable unit installation bolt to the specified torque.
Tightening torque: 5.0 ± 1.0 Nm (44 ± 9 inch lbs.)
4. Check the selector lever operation.
>>B<< TRANSAXLE CONTROL CABLE ASSEMBLY (TRANSAXLE SIDE)/ADJUSTING NUT INSTALLATION
1. Place the selector lever and manual control lever in the N position.
2. Place the cable stud into the manual control lever slot and install the adjusting nut loosely. Gently push the transaxle control cable into the manual control lever slot until the cable is taut. Tighten the adjusting nut to the specified torque.
Tightening torque: 12 ± 2 Nm (107 ± 17 inch lbs.)
INSPECTION
Check the cable assembly for function and for damage.
Removal Steps 1-13:
DISASSEMBLY AND ASSEMBLY