B1541

DTC B1540: Occupant classification-ECU malfunction
DTC B1541: Occupant classification-ECU calibration malfunction
DTC B1542: Occupant classification sensor (S1) malfunction
DTC B1543: Occupant classification sensor (S2) malfunction
DTC B1558: Occupant classification-ECU ID-cord malfunction

DTC SET CONDITIONS

B1540 - B1558:

- These DTC are set when a fault is detected in the occupant classification-ECU. The most likely causes for this code to be set are shown in the table:

TROUBLESHOOTING HINTS
Malfunction of the occupant classification-ECU

DIAGNOSIS

Required Special Tools:
- MB991958: Scan Tool (MUT-III Sub Assembly)
- MB991824: Vehicle Communication Interface (V.C.I.)
- MB991827: MUT-III USB Cable
- MB991910: MUT-III Main Harness A (Vehicles with CAN communication)

Recheck for diagnostic trouble code.

Check again if the DTC is set.




1. Erase the DTC.
2. Turn the ignition switch to the "ON" position.
3. Check if the DTC is set.
4. Turn the ignition switch to the "LOCK" (OFF) position.

Q: Is the DTCs set?

YES: Replace the front seat slide adjuster (Refer to Interior, front seat assembly).

NO: There is an intermittent malfunction such as poor engaged connector(s) or open circuit (Refer to How to Cope with Intermittent Malfunction).